About vaseitaly78

Description

10 Strategies To Build Your Peugeot Keys Empire
Peugeot 208 Key Replacement

It is best to leave the replacement of Peugeot keys for 208 to auto locksmiths that have the required equipment and know-how. They will be able to create and program new keys much faster than a dealership would and at a lesser cost.

If the key fob stopped locking or unlocking your doors it could be due to a dead coin battery. There are many other reasons that the key might be malfunctioning.

Dead Coin Battery

A dead coin battery will stop your Peugeot 208 from locking and unlocking, and also stopping it from starting the engine. If this is the scenario, you'll need make use of the backup starting procedure that is detailed in the owner's manual to your vehicle.

Another reason your 208 might not start is that the spark plugs have worn down. Spark plugs are what ignite the fuel to start the engine. They have a limited life span. If they're not used enough they will eventually fail.

Fortunately, there's an easy solution for this issue. Verify the voltage of your battery using a multimeter. If the voltage is below 11,5 volts, it's time to replace it. If the battery is corroded, it is important to clean its contacts. You can do this by lifting the rubber covers that protect the two terminals of the battery and using a wire brush to remove any corroded components of the battery. You should then reconnect your cables to connect the positive and negative poles.

Water Damage

If your 208 won't turn on and the battery is not flat then you should check whether the spark plugs work. It could be that they are dirty and do not spark. This can be easily corrected by cleaning the spark plugs in an workshop.

Peugeot cars use keys that are transponder-type and integrates with the car's immobiliser system. This makes sure that only the correct key can turn the engine. If the chip inside the Peugeot key is damaged, it won't send the correct signal to the vehicle.

Water damage is a frequent reason for this issue. This is particularly common in colder climates, where the vehicle may have been exposed to rain or snow. If this is the case, you should get in touch with a reputable locksmith who has all the tools and equipment required to change the key's programming. They will also have all the latest technology and machinery needed to create the Peugeot smart key. The process shouldn't take longer than 15 minutes.

Contacts of the battery may be damaged.

Peugeot changed from the old carbon-encased transponder chips and introduced a new type of chip that uses electronic components in a circuit board. The new system is great when it's new, but the circuit boards degrade over time and cease to function properly.

This could prevent the immobiliser from triggering so that your vehicle won't be able to start. Contact a Peugeot specialist or a locksmith if this is the case.

Another issue that is common is when the battery in the key fob is dying, this causes the blade of the key to stop from entering the lock. peugeot 207 key can replace the battery and cut a fresh blade for you, this is usually a simple fix.


Faulty Receiver Module

If your Peugeot key fob has stopped working after dropping it on the ground, being exposed to a sudden rain or accidently washing it, it could be due to a faulty receiver module. The receiver is responsible for sending radio frequency signals to the on-board computer which controls the centralized locking system within your Peugeot vehicle.

The key fob itself is fitted with rubber seals that block water from getting to the chip inside. However, prolonged exposure to water can cause damage to these seals and the chip. Submerging the key fob into sea water at the beach or throwing it into the pool could be especially damaging because of the high salt content.

If your Peugeot spare key fob isn't working, you'll need to have the module replaced. This can only be done by an Peugeot specialist or an expert auto locksmith. Peugeot keys like other cars are secured by an immobilizer system. This requires the correct programming to allow the car to start. This is the reason that you should only rely on a Peugeot locksmith to create and program the replacement.

Computer on-board is not working properly

The on-board computer of your Peugeot is responsible for various systems in your car, including power windows and airbags. The computer on board will display a code if something goes wrong. This code will be stored within the system until the issue is fixed. Usually, this will mean replacing the onboard computer.

The most common reason for the warning light for airbags to flash is corrosion or loose connections in the sensor. This could be due to wear and tear, aging or exposure to salt and moisture. This issue must be dealt with as soon as you can, because an airbag that is malfunctioning could be dangerous in the event of an accident.

If your Peugeot is showing a card not detected error, then the key battery in the key fob might be weak or dead. This will stop the key fob sending a signal to deactivate the vehicle's immobilizer. You can test this by pressing the unlock button on the key fob and then trying to start your vehicle. If this fails, the key battery must be replaced.